How To Install The Led Street Light Correctly ？
1.First of all, the installation height of the LED street light on the same road (from the light source to the ground), the height and the direction of illumination should be consistent. The excavation size of the foundation pit should meet the design requirements. The strength of the foundation concrete should not be lower than C20. The cable jacket in the foundation should pass through the base center, 30-50 mm above the base plane. The water in the pit must be removed before the reinforced concrete foundation is poured. Metal parts used to install LED street lights, such as light poles, lamp arms, hoops, bolts and pressure plates, shall be hot dip galvanized and galvanized. The quality of anticorrosion shall comply with the relevant national standards.
2.The street lamp manufacturer introduces that the vertical center line of the LED lamp unit should be the same as the longitudinal center line of the lamp arm. The horizontal line of the LED light installation should be parallel to the ground, and the visual measurement should not be inclined after tightening. The LED lamp holder is fixed firmly, and the adjustable lamp holder should be adjusted to the correct position according to the design. The lamp socket wiring should meet the requirements. LED arm, lamp and pole must not be connected. The perforations or nozzles should be smooth and burr-free. Insulating sleeves or bandages shall be used and the length of the bandage shall not be less than 200 mm. Various nuts, washers and spring pads should be secured. The distance between the nuts after tightening must not be less than two.
ekiledlighthousing.com
judi@ekilhs.com